Milliken — Send a clear fabric inquiry

Material reference. Quantity. Destination.

Before you send

Use the list as the spine of the message. For a protective textile, add the exposure you care about, such as heat, cut, or surface wear, and the method if you already have a report, for example ISO 13937 for tear strength or ISO 13934-1 for tensile strength. For upholstery, add the seating or drapery context, the care you expect, and whether pile or a flat weave is the construction under review. Abrasion resistance under ISO 12947 and pilling under ISO 12945 answer different questions from handfeel. Colourfastness stays in its own line. A telephone number and a street address are not published on this page, so the form is the route for the brief.

Write numbers with their units. A mass target belongs in g/m², and ISO 3801 is the method name to cite only when a measured GSM is attached. A width target in cm should say whether you mean the full cloth or the usable width inside the selvedge. Warp and weft, or the knit path, belong with that width. If the yarn size matters on a protective construction, name denier or dtex and do not mix that figure with a cotton count. Composition should be readable as percentages by mass that add to 100. If the upholstery question is seam slippage after a stated clean, describe the clean and the seam, and leave the result as something still to be checked. Air permeability and stretch recovery, if either matters, need their own method names.

Put the shade note on its own line from the construction note. A colour comment made on a finished piece should not be read as approval of an unfinished greige cloth. If you are sending a second cutting, say what you hope is unchanged and what you hope is different. Quantity and destination come after that cloth description so the two conversations stay readable in one message.

If the fibre family is still open, write both readings. Natural fibres are in the note for handle and moisture take-up. Synthetic fibres are in the note for strength, drying, and a functional finish. That is a selection split, not an environmental ranking. If the cloth is coated, ask about coating add-on and adhesion. If it is laminated, ask about the film and peel on the stated specimen. A stock length needs a dated batch. A custom development needs the sample and the later approval step. Unknown points stay blank. This page does not supply a measured GSM, a certificate number, or a delivery date.

The enquiry is handled under the Privacy Policy.