Pick the setting first, then the property that should decide the next cutting of protective or upholstery cloth.
Ask a material questionInterior contact and industrial exposure ask for different evidence, even when two cloths look close in weight. An upholstery fabric lives against seating foam, daylight, and a cleaning routine. A protective industrial textile may face heat, sharp edges, or repeated abrasion in a work setting. Describe the room or the process, not a finished product you want this site to supply. Chairs, garments, and installed panels stay outside the material brief.
Choose one lead question so the sample is not asked to prove everything at once. Handle and appearance are judged on a physical piece under the light and the touch that match the use. Functional behaviour needs a named requirement. For seating, that might be abrasion or pilling with the method written beside it. For protective cloth, that might be tear, tensile strength, or a heat-related observation, again with the specimen state. Liquid water resistance and vapour movement are different tests; do not fold them into one word.
Two material disputes stay open until the brief picks a side. Natural fibres are discussed when handle and moisture take-up lead. Synthetic fibres are discussed when strength, drying, or a functional finish lead. An environmental conclusion needs a scoped assessment and is not settled by the fibre name. Coating and lamination split the next choice: a coated cloth is checked for coating add-on, adhesion, and softness, while a laminated cloth is checked for the film, peel, and the specimen state. Stock and custom development split again. Stock needs a dated batch and a note on whether that batch can be repeated. Custom work needs a sample, a named test, and a bulk-approval step. This page does not state which route is on hand.
Use a physical sample and an agreed shade reference. Note pile direction or weave face, and whether the finish on the cutting is the finish you expect in use. A screen swatch can set a colour direction. It does not close a shade band.
Identify one relevant requirement and its test context. Keep method, version, conditioning, and the construction that was tested in the same note. Abrasion can be discussed against ISO 12947, pilling against ISO 12945, tensile strength against ISO 13934-1, and tear strength against ISO 13937. Hydrostatic head under ISO 811 does not describe water vapour transmission under ISO 11092. Mass uses ISO 3801 when a measured g/m² is claimed, and dimensional change uses ISO 5077 when shrinkage is the question. A result from a different finish state does not travel automatically to the cloth you want to order. Colourfastness, seam slippage, and air permeability stay in their own lines.
Composition, construction, quantity, and destination give the branch a practical end. Add GSM with its unit, usable width rather than only the full cloth width, and the finish name if you know it. If yarn linear density matters for a protective construction, state the unit you are using and do not mix it with a cotton count. If the upholstery question is seam slippage or dimensional change after cleaning, say so as a question, not as a value this page already holds.
Batch colour and piece-to-piece handle are discussion points once a reference exists. They are not settled by a family name. Write the approval note you will use later: the cutting identity, the light, and the property that was accepted. Then add quantity and destination so the commercial context can be read without replacing the cloth description.
An application page is a way to frame the environment, the stress and the assembly question. It is not a list of completed installations. Describe contact, exposure, care and processing separately, then ask which evidence belongs to that condition.
| Condition | Question | Evidence context |
|---|---|---|
| Daily contact | What touch, care and surface change matter? | Physical sample and the stated care context |
| Moisture | Is the question liquid resistance or vapour movement? | Method and specimen conditioning |
| Assembly | How will the textile be cut or joined? | Construction and usable width |
| Colour | Which physical reference is under review? | Shade approval notes, not a screen swatch |
Exposure, care, and processing make the brief specific.
Discuss your fabric requirements